ISDNAUDIO.COM Discussion and help forum

ISDNAUDIO.COM Discussion and help forum
http://www.forum.isdnaudio.com/yabb2-cgi/YaBB.cgi General >> Techical support >> Zephyr not framing on cdq Prima Codecs http://www.forum.isdnaudio.com/yabb2-cgi/YaBB.cgi?num=1085410042 Message started by From the old message board on May 24^th, 2004 at 3:47pm

Title: Zephyr not framing on cdq Prima Codecs
Post by From the old message board on May 24^th, 2004 at 3:47pm

Trying to connect from S.Africa to UK from a Telos Zephyr to a CDQ Prima codec and got as far as the Zephyr hearing and locking with the Prima but the Prima not hearing us and also not framing.

Is the problem with the Prima and how can one fix it?Settings, L2 Mono TX and RX, 48 Khz and 64 Kbps HELLLLLLP ?

Title: Re: Zephyr not framing on cdq Prima Codecs
Post by Edwin van den Oosterkamp on May 24^th, 2004 at 3:48pm

The problem is most likely that the CDQ Prima is set in “decoder dependent” mode – in this mode it is not compatible with the Telos unit.

To set the Prima in the Telos compatible “independent mode”, go into the “Decoder->Indep” menu and set it to “yes”. The settings of the decoder should then still match the encoder.