Hi everyone,

As i'm new on this forum i'm not really sure that my question is relevant but i found no solution by myself so i hope someone can help me.

Here is the problem : I try to connect my cdq prima 210 (in france) to a cdq prima 120 (in england). If i trust my spech sheet , as i work in SpeedDial1 (MPEG2-2lines-128kbits/s- Joint Stereo) the Prima 120 should be working in SpeedDial18 to get the compatible codec. But ('cause there is always a but...) the 2 boxes can't frame with each other. The 2 lines are connected but the codec don't seems to be right. I also tried to switch to SpeedDial27 on the 210 and SpeedDial19 for the 120 (equivallent to Zephyre codec).... nothing worked.

So if anyone can help me to resolve this problem it would be really nice.

Thx a lot.

ps : I also tried of course to manually set the boxes but didn't work either.

Hello Carlito,

The difference I usually see in setup is that in the UK most Primas are setup for "independent mode = off", where in the rest of Europe that setting is usually turned on.
I'm nut sure which speeddial setting that might be, but if you're setting up the unit manually then the dependent mode option is in the "decoder" menu. To communicate with the UK unit you probably need to have the setting "Indep" set to "no".

Best regards,

Edwin.